page-banner
Jwell was founded in 1997, China Plastics Machinery Industry Association vice president unit, plastic extrusion equipment, chemical fiber spinning complete sets of equipment manufacturers.

Single Screw Extruder

  • PP Non-woven Fabrics Extruder

    PP Non-woven Fabrics Extruder

    JWM series Non-woven fabrics Extruder are specialized in PP Non-woven fabrics production. Normally it uses two extruders in series.

  • Single Screw Extruder for Profile

    Single Screw Extruder for Profile

    This model of equipment mainly used to extrude profile, the structure and form of screws and barrels vary a lot, and the screws and barrels are processed precisily which can gurantee a good plasticization, high capacity and can meet different customers needs,
    the electrical controling parts are equiped in high class which made it safe to operate. Suitable for PVCPCABS Profile.

  • Single-screw Extruder for UHMW-PE

    Single-screw Extruder for UHMW-PE

    The extruder has our patented design for screw and barrel, which can be used to process more than 1.5 million molecular of the powder material. By overcoming poor flow ability, Mechanical properties decreasing due to easy degradation, etc, The extruder can have stable output and reliable plasticization during production.

  • HDPE High Efficiency Single Screw Extruder

    HDPE High Efficiency Single Screw Extruder

    It is widely used in the area of water supply and gas supply. Feeding section is grooved structure with temperature controller, and easy to get high capacity and stable extrusion. With advanced BM screw structure, it is able to divide the HDPE material from solid to liquid.

  • New type high efficient energy saving extruder

    New type high efficient energy saving extruder

    Features:By using the new type barrier screw design, this extruder has a high extrusion capacity in high RPM with the low energy consumption, and this extruder can gain a good mixing effect in the low temperature, and this extruder can control the material shearing to get the ideal and even melt temperature, so that the ripple mark in the inner wall of the big diameter pipe can be avoided.